 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-269-34-1
CRANKSHAFT AND MAIN BEARINGS
This task covers:
a. Removal (page 2-115)
d. Inspection/Replacement (page 2-120)
b. Disassembly(page 2-119)
e. Installation (page 2-122)
c. Cleaning (page 2-120).
INITIAL SETUP
Tools
Materials/Parts
Caliper, micrometer, OD
Oil, engine (item 32, appendix B)
Clamp, piston holddown
Rags, wiping (item 42, appendix B)
(eight required)
Seal, crankshaft
Face, inserted hammer, soft-plastic
Seal, rear main bearing (two required)
Hammer, ball-peen, machinist's
Sleeve, crankshaft (as needed)
Hammer, slide
Solvent, drycleaning (item 49, appendix B)
Handle, ratchet, 1/2-inch drive
Tag, marking (item 50, appendix B)
Hoist, with lifting slings
Tape, plastic gage (item 53, appendix B)
Holder, inserted hammer-face
Washers, cylinder block (ten required)
Indicator, dial
Washers, main and rear main bearing cap
Installer, crankshaft oil seal
(ten required)
and sleeve
Installer, main bearing cap seal
Personnel Required
Knife, pocket
Puller, gear
One
Puller, gear adapter
Puller, seal
Equipment Condition
Punch, drive-pin, 1/4-inch
Cylinder heads removed (page 2-102).
Punch, drive-pin, 3/8-inch, blunt-end
Front crankcase cover removed (page 2-197).
Remover and installer, main bearing cap
Flywheel housing removed (page 2-137).
Socket, 1/2-inch drive, 9/16-inch
Engine oil pump removed (page 2-208).
Socket, 1/2-inch drive, 11/16-inch
Socket, 1/2-inch drive, 13/16-inch
Studs, guide (two required)
Wrench, open-end, 2-inch
Wrench, torque, 1/2-inch drive
2-114
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals