|
|
TM 9-2320-269-34-1
CRANKSHAFT AND MAIN BEARINGS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
17.
Cylinder block (1)
Crankshaft (8)
Using lifting sling and hoist, and turn-
ing as necessary to clear sides of block
(1), take out.
18.
Four upper bearing
a
Roll out, tang end first.
shells (14) and
b.
Tag for proper placement during
one upper thrust
installation.
flange (15)
DISASSEMBLY
CAUTION
Be careful not to nick or scuff the crankshaft flange when removing sleeve.
NOTE
If wear sleeve only shows one wear path, do not do step 19.
19.
Crankshaft (8)
Wear sleeve (16)
a
Using 3/8-inch blunt-end drive-pin
punch, and ball-peen hammer, mark
surface In several places.
b.
Using plastic face hammer, tap surface
until sleeve (16) expands enough to be
taken off.
c.
Take off.
d.
Get rid of.
TA237982
2-119
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |