|
|
TM 9-2320-269-34-1
CRANKSHAFT AND CAMSHAFT TIMING GEARS - CONTINUED
INSTALLATION - CONTINUED
NOTE
FOLLOW-ON MAINTENANCE: Install front crankcase cover (page 2-197).
TASK ENDS HERE
FRONT CRANKCASE COVER
This task covers:
a. Removal (page 2-198)
d. Inspection/Replacement (page 2-200)
b. Disassembly (page 2-198)
e. Assembly (page 2-200)
c. Cleaning (page 2-200)
f. Installation (page 2-200)
INITIAL SETUP
Tools
Materials/Parts - Continued
Extension, 1/2-inch drive, 3-inch
Lockwashers, plate (two required)
Face, inserted hammer
Packing, preformed, air compressor base
Handle, ratchet, 1/2-inch drive
Rags, wiping (item 42, appendix B)
Holder, inserted hammer-face
Seal, oil
Puller, seal
Solvent, drycleaning (item 49, appendix B)
Screwdriver, flat-tip, 1/8-inch
Socket, 1/2-inch drive, 9/16-inch
Personnel Required
Wrench, open-end, 7/16-inch
Wrench, open-end, 11/16-inch
Two
Wrench, open-end, 1 1/8-inch
Wrench, pipe, 14-inch
Equipment Condition
Wrench, torque, 1/2-inch drive
Engine oil pan removed (page 2-203).
Materials/Parts
Crankshaft pulley removed (page 2-131).
Idler pulley arm removed
Gasket, cylinder block
(TM 9-2320-269-20-1).
Gasket, plate
Water pump to crankcase manifold removed
Lockwashers crankcase cover
(11 required)
Air compressor removed
Lockwashers, air compressor base
(TM 9-2320-269-20-1).
(three required)
Fuel injection pump drive removed
2-197
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |