|
|
TM 9-2320-269-34-1
WATER PUMP-TO-CRANKCASE MANIFOLD
This task covers:
a.
Removal (page 2-410)
d.
Inspection/Replacement (page 2-412)
b.
Disassembly(page 2-411)
e.
Assembly (page 2-412)
c.
Cleaning (page 2-412)
f.
Installation (page 2-413)
INITIAL SETUP
Tools
Materials/Parts - Continued
Handle, ratchet, 3/8-inch drive
Lockwasher, cylinder block (two required)
Pail, utility, 12-quart
Lockwasher, water pump body (two required)
Socket, 3/8-inch drive, 9/16-inch
Rags, wiping (item 42, appendix B)
Vise, machinist's
Sealant, gasket (item 44, appendix B)
Wrench, open-end, 112-inch
Solvent, drycleaning (item 49, appendix B)
Wrench, open-end, 11/16-inch
(two required)
Personnel Required
Wrench, open-end, 1-inch
Wrench, open-end, 11/8-inch
One
Materials/Parts
Equipment Condition
Gasket, body outlet
Fan assembly and modulated fan drive assembly
Gasket, cross-over
removed (TM 9-2320-269-20-1).
ACTION
LOCATION
ITEM
REMARKS
1.
Elbow (1)
Water pipe (2)
a.
Put pail underneath to catch draining
fluid.
b.
Using 1-inch and 1 1/8-inch open-
end wrenches, unscrew and take off.
c.
Allow fluid to drain.
d.
Get rid of fluid (page 2-46).
2.
Connector (3)
Water pipe (4)
Using two 11/16-inch open-end wrenches,
unscrew and take off.
3.
Water pump-to-
Two screws (6) and
a.
Using 1/2-inch open-end wrench, un-
lockwashers (7)
screw and take out.
manifold (5)
b.
Get rid of lockwashers (7).
2-410
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |