NYLON TUBING

TM9-2320-270-20-2

NYLON TUBING

This task covers:

d. Repair of Tube-End Section (page 4-643)

a. Replacement (page 4-634)

e. Repair of In-Line Section (page 4-647)

b. Repair at Connection (page 4-639)

c. Repair of In-Line Break (page 4-641)

INITIAL SETUP

Materials/Parts Continued

Tools

Nylon airhose (as required)

Hammer, plastic

Sleeve, compression (as required)

Handle, ratchet, 3/8-inch drive

Union, tubing, brass compression

Pliers, diagonal cutting

(as required)

Pliers, long-nose

Soap, liquid (item 14, appendix C)

Pliers, slip-joint, straight-nose

Tape, pressure sensitive

Knife, pocket

(item 21, appendix C)

Socket, 1/2-inch, 3/8-inch drive

Wrap, tie (item 24, appendix C)

Wrench, box, 1/2-inch

Wrench, open-end, 9/16-inch

Personnel Required

Wrench, open-end, 5/8-inch

One

Materials/Parts

Insert, nylon tubing reinforcing

(as required)

ACTION

REMARKS

ITEM

LOCATION

NOTE

This procedure applies to all nylon tubing air lines. Quick release valve-to-bulkhead

fitting nylon tube is shown.

REPLACEMENT

WARNING

Make sure all pressure is drained from air system before disconnecting air lines. Parts

under pressure can, when removed, fly off with great force causing injury to personnel.

NOTE

Tag tubes according to general maintenance instructions (page 4-1).

4-634