Handle Replacement.

TM 32-5865-216-24&P

Identification

Plate

Replacement.

NOTE

If identification plate is being replaced,

ensure that correct tunable coupler serial

number has been permanently marked on the

identification plate.

Position the identification plate (28) in place and secure with

two rivets (29) using the riveting kit.

Handle Replacement.

Place each handle (30 or 66) in position and secure with two

screws (31), lock washers (32) and flat washers (33).

When the rear handle is replaced, replace circuit card

assemblies A1 through A5 (7 through 11) in accordance with

Replace the top cover (3) in accordance with paragraph 5-11.1.

Connector J1 Replacement.

Solder the wire from relay K2 (55), to center terminal of

connector J1 (37).

Carefully push the wire back through the mounting hole and

position the connector in place.

Secure the connector and connector cap chain (38) to the

tunable coupler with four screws (34), lock washers (35) and

flat washers (36).

The chain is secured at the lower right

mounting hole.

Replace the top cover (3) in accordance with paragraph 5-11.1.

Connector J3 Replacement.

Position Connector J3 (41) in place with wide key slot oriented

at 3 o'clock, i.e., toward J4 (49), and secure with four screws

(43), eight flat washers (44), four lock washers (45), and four

nuts (46). The chain attaching connector cap (40) is secured

at lower right mounting hole.

Use insertion tool to insert wires into connector as previously

tagged.

Remove the connector cap (40) from the blank connector (42) and

secure on connector J3.

Replace bottom panel (5) in accordance with paragraph 5-11.

5-33