Connector J4 Replacement.

TM 32-5865-216-24&P

Use insertion tool to insert wires into connector as previously

tagged.

Position connector J4 (49) in place and secure with jam nut

(48).

Secure FL5 to chassis with screws and washers.

Remove the connector cap (47) from the blank connector (50) and

secure on connector J4.

Replace the bottom panel (5) in accordance with paragraph

5-11.2.

Blank Connector for J2 Replacement.

Position the blank connector (56) in place and secure with

three screws (51) and nuts (52) and four lock washers (54) and

flat washers (53).

Replace top cover (3) in accordance with paragraph 5-11.1.

Blank Connectors for J3 and J4 Replacement.

Position the blank connector (50 or 42) in place with the

connector cap chain (47 or 40) and secure with four screws

(57), lock washers (58), flat washers (59), and nuts (60). The

chain for the connector cap is secured at the low corner

nearest the connector it will cover.

Replace the bottom panel (5) in accordance with paragraph

5-11.2.

Filter FL5 Replacement.

Replace the filter FL5 (61) inside the filter shield (65).

Position the filter shield (65) in place and secure with two

screws (62), lock washers (63) and flat washers (64).

Solder the wires to filter as previously tagged.

Replace the bottom panel (5) in accordance with paragraph

5-11.2.

Riveting.

To replace a rivet(s) on a vent cover or the identification

plate obtain and install appropriate size rivet from riveter kit (See

MAC, App. B). Using the riveter and appropriate size head, install the

replacement rivet.

5-34