Vent Cover and Screen Assembly Replacement

TM 32-5865-216-24&P

Position the vent cover (13) and screen assembly (14) in place

and secure with eight 3/32 inch diameter x 1/4 inch long rivets

(12) using the riveter kit.

Replace the top cover (3) or bottom panel (5) in accordance

with paragraph 5-11.1 or 5-11.2 as required.

Resistors R1, R2 and R3 Replacement.

Secure each resistor to the chassis with two screws (16), lock

washers (17), flat washers (18) and nuts (19).

Solder the two wire to each resistor as previously tagged.

Replace bottom panel (5) in accordance with paragraph 5-11.2.

Replace top cover (1) in accordance with paragraph 5-11.1

Front Hook Replacement. Position each hook (23) in place on

the front panel (24) and secure with two screws (20), flat washers

(21), and lock washers (22).

Diode CR1 Replacement.

Position diode CR1 (25) in place with cathode connected at

terminal E8 (39) and anode at terminal E7 (39).

Solder the two wires to the terminals and diode as previously

marked.

Replace bottom panel (5) in accordance with paragraph 5-11.2.

Decal Replacement.

After surface has dried from the decal removal procedure,

position the new decal (26) in place so that it is located

symmetrically and can be read from the front of the unit.

Peel away the decal protective backing and press firmly in

place.

Replace top cover (1) in accordance with paragraph 5-11.1.

Warning Plate Replacement.

After surface has dried from the warning plate removal

procedure, position the new warning plate (27) in place so that

it can be read when facing the front panel with the tunable

coupler top side up.

Peel away the warning plate protective backing and press firmly

in place.