|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
BO. PERSONNEL HEATER CIRCUIT.
Step 1.
Disconnect wiring harness from personnel heater control box.
Place red probe on pin D (lead 411). Ground black probe. Set
START-OFF-RUN switch to START. If multimeter indicates
about 24 volts, go to step 2. If multimeter indicates no voltage,
replace personnel heater control box. Refer to page 2-1103.
Set START-OFF-RUN switch OFF. Connect wiring harness.
2-362
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |