GENERATOR CHARGING CIRCUIT. (Cont) - TM-9-2350-238-20-10169

TM 9-2350-238-20-1

Step 6.

Check resistance between plug pin C (lead 478) and ground. Check

resistance between plug pin D (lead 1 ) and ground. If multimeter indicates

0 to 4 ohms on each pin, go to step 12. If multimeter indicates more than

4 ohms on one or both pins, go to step 7. Connect wiring harness to

voltage regulator.

Step 7.

To access generator, remove hull engine compartment deck assembly lid,

refer to page 2-935; and remove radiator support beam, refer to page

2-525. Disconnect lead 3 from generator terminal E-. Check continuity

between lead 3 and ground. If continuity exists, go to step 8. If no

continuity exists, repair lead 3 between generator and ground. Refer to

page 2-371. Connect lead 3 to generator terminal E-.

2-143