Alignment - TM-9-2320-360-20-20219

TM 9-2320-360-20-2

7-6. 12-VOLT (REAR) ALTERNATOR BELT ADJUSTMENT/REPLACEMENT (CONT)

c.1. Alignment

NOTE

This sub-paragraph is only required if

a new mounting bracket or alternator

was installed.

(1) Place a straight edge across the outside edge of

engine pulley (1).

(2) Measure gap between straight edge and belt

(2) at engine pulley (1) and alternator pulley

(3) Gap should be equal ( 0.10 in. (2.5 mm)).

NOTE

Do steps (3) thru (9) if alignment is

not within specifications.

(3) Remove alternator belts (para 7-6a).

(4) Remove alternator (para 7-3).

(5) Add washer (4) to move alternator to rear; delete

washer (4) to move alternator to front

(6) Install alternator (para 7-3).

(7) Install alternator belts (para 7-6b).

(8) Adjust alternator belts (para 7-6c).

(9) Repeat steps (1) and (2) to verify adjustment.

d. Follow-On Maintenance

(1) Install alternator, front engine, and lower engine

access panels (para 16-2).

(2) Close engine hood (TM 9-2320-360-10).

7-19.0 Change 2