MAGNETIC SWITCH

TM9-2320-270-20-1

STARTER - CONTINUED

NOTE

FOLLOW-ON MAINTENANCE:

1. Close left side of hood and install left hood side panel (TM 9-2320-272-10).

2. Connect battery ground cable (page 4-444).

3. Check operation (TM 9-2320-270-10).

TASK ENDS HERE

MAGNETIC SWITCH

This task covers:

b. Installation (page 4-234)

INITIAL SETUP

Materials/Parts Continued

Tools

Sand paper, fine grit (item 12, appendix C)

Handle, ratchet, 3/8-inch drive

Tag, marking (item 18, appendix C)

Screwdriver, cross-tip, number 3

Socket, 1/2-inch, 3/8-inch drive

Personnel Required

Wrench, open-end, 1 1/32-inch

One

Materials/Parts

Equipment Condition

Lockwasher, ignition switch and

ground terminal (two required)

Right side of hood open and right side panel

Lockwasher, battery and starter

removed (TM 9-2320-270-10).

terminal (two required)

Battery ground cable disconnected

Lockwasher, magnetic switch to fire-

wall (two required)

ACTION

REMARKS

ITEM

LOCATION

REMOVAL

WARNING

Make sure battery ground cable is disconnected before doing this task. Failure to

disconnect battery ground cable can cause personal injury or damage to electrical

system.

NOTE

Tag wires according to general maintenance instructions (page 4-1).

4-232