|
|
TM 9-2320-269-34-1
REAR-REAR AXLE DIFFERENTIAL
This task covers:
a. Removal (page 2-909)
d. Inspection/Replacement (page 2-916)
b. Disassembly (page 2-911)
e. Assembly (page 2-916)
c. Cleaning (page 2-915)
f. Installation (page 2-929)
INITIAL SETUP
Tools
Tools - Continued
Bar, cheater, 30-inch
Tester, spring scale
Bar, pry, 24-inch
Vise, machinist's
Block, wood
Wire or strong cord, 36-inch
Caliper, micrometer, OD
Wrench, adjustable,12-inch
Caps, vise jaw
Wrench, open-end, 3/4-inch
Driftpin, brass, 3/4-inch
Wrench, torque, 1/2-inch drive,
Fixture, riveting
0 to 250 ft-lb capacity
Gage, thickness, ribbon
Wrench, torque multiplier, 3/4-inch drive,
Grinder, pencil, portable
0 to 1000 ft-lb capacity
Hammer, ball-peen, machinist's
Handle, ratchet, 1/2-inch drive
Materials/Parts
Handle, ratchet, 3/4-inch drive
Hoist, with lifting cables, 4000-lb
Cloth, emery (item 8, appendix B)
lifting capacity
Cups, bearing; bearing cage (two required)
Indicator, dial
Gasket, differential carrier
Jack, dolly-type
Lockwasher, oil scoop
Jack, hydraulic hand, 10-ton
Lockwashers, carrier to housing
Pinion setting gage set
(12 required)
Pliers, slip-joint, angle-nose
Lubricant, rear axle (tiem 28, appendix B)
Press, arbor
Paint, oiled red lead (item 37, appendix B)
Press, hydraulic, 50-ton capacity
Pin, cotter, bearing locks (two required)
Puller, gear and bearing
Pin, cotter, yoke
Punch, drive-pin, blunt-point,
Plates, lock, upper and lower bearing caps
3/8-inch
Rags, wiping (item 42, appendix B)
Punch, drive-pin, 3/16-inch
Rivets, flanged case (12 required)
Screws, puller, 1/2-inch NC, 3-inch
Sealant, gasket (item 44, appendix B)
long (two required)
Seal, oil
Scribe, machinist's
Solvent, drycleaning (item 49, appendix B)
Sleeve, oil sealer installer
Spacer, pinion assembly
Stand, overhaul
Tag, marking (item 50, appendix B)
Socket, 1/2-inch drive, 7/16-inch
Washers, thrust side (two required)
Socket, 1/2-inch drive, 9/16-inch
Washers, thrust pinion (four required)
Socket, 1/2-inch drive, 3/4-inch
Socket, 1/2-inch drive, 15116-inch
Personnel Required
Socket, 3/4-inch drive, 13/16-inch
Socket, deep well, 314-inch drive,
One
1 7/8-inch
2-908
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |