 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 93-2320-269-34-1
FRONT AXLE ASSEMBLY - CONTINUED
INSTALLATION - CONTINUED
NOTE
FOLLOW-ON MAINTENANCE: Install steering knuckles and kingpins (page 2-823).
TASK ENDS HERE
STEERING KNUCKLES AND KINGPINS
This task covers:
a. Removal (page 2-824)
d. Inspection/Replacement (page 2-828)
b. Disassembly (page 2-826)
e. Assembly (page 2-828)
c. Cleaning (page 2-827)
f. Installation (page 2-830)
INITIAL SETUP
Tools
Materials/Parts
Driftpin, brass, 3/4-inch
Bushing, steering knuckle (as needed)
Driftpin, bronze, 3/4-inch,
Grease, GAA (item 20, appendix B)
18-inch long
Lockwasher, bracket
Extension, 3/8-inch drive, 6-inch
Lockwasher, knuckle cap (six required)
Gage, thickness
Packing, knuckle (two required)
Hammer, ball-peen, machinist's, 3-lb
Pin, cotter (two required)
Handle, ratchet, 3/8-inch drive
Rags, wiping (item 42, appendix B)
Handle, ratchet, 3/4-inch drive
Seal, front axle (two required)
Jack, hydraulic, hand
Shims and washers (as needed)
Pliers, slip-joint, angle-nose
Solvent, drycleaning (item 49, appendix B)
Press, arbor, hand-operated
Punch, drive-pin, 3/16-inch
Personnel Required
Sleeve, knuckle bushing remover
Socket, 3/8-inch drive, 1/2-inch
One
Socket, 3/8-inch drive, 7/16-inch
Socket, deep well, 3/8-inch drive,
Equipment Condition
9/16-inch
Socket, 3/4-inch drive, 1 7/8-inch
Front wheels and hubs removed
Vise, machinist's
(TM 9-2320-269-20-1).
Wrench, open-end, 7/16-inch
Tie rod removed (TM 9-2320-269-20-1).
Wrench, open-end, 1/2-inch
Brake chambers and mounting brackets
Wrench, torque, 3/8-inch drive
removed (TM 9-2320-269-20-1).
Wrench, torque, 3/4-inch drive
Brakes and backing plates removed
0 - 600 ft-lb capacity
(TM 9-2320-269-20-1).
Slack adjusters removed
(TM 9-2320-269-20-1).
2-823
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals