|
|
TM 9-2320-269-34-1
ANTILOCK CONTROL MODULES
This task covers:
a. Removal (page 2-498)
c. Installation (page 2-500)
b. Inspection/Replacement
INITIAL SETUP
Tools
Materials/Parts
Handle, ratchet, 3/8-inch drive
Lockwashers, control module (three required)
Handle, speeder, 1/4-inch drive
Pliers, round-nose, long
Personnel Required
Screwdriver, flat-tip, 114-inch
Socket, 1/4-inch drive, 318-inch
One
Socket, 3/8-inch drive, 112-inch
Wrench, open-end, 5/16-inch
Equipment Condition
Wrench, open-end, 1/2-inch
Battery cables disconnected
(TM 9-2320-269-20-1).
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
There are three module controls, each mounted on vehicle right frame, near each axle. The front module is
mounted on the outside of the frame. The two rear modules are mounted on the inside of the frame.
Removal procedure for all modules is the same.
1.
Module control (1)
Three screws (2)
Using 3/8-inch socket and speeder handle
with 1/4-inch drive, unscrew until cover
is free.
2
Cover (3) and three
Take off.
screws (2)
3
Connectors (4)
Using long round-nose pliers on raised
part of connector, pull out.
4.
Ground wire
Nut (6)
Using 5/16-inch open-end wrench, un-
terminal (5)
screw and take off.
2-498
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |