|
|
TM 9-2320-269-34-1
CAMSHAFT
This task covers:
a.
Removal (page 2-184)
d.
Inspection/Replacement (page 2-186)
b.
Disassembly (page 2-185)
e.
Assembly (page 2-187)
c.
Cleaning (page 2-186)
f.
Installation (page 2-188)
INITIAL SETUP
Tools
Materials/Parts
Compressor, reciprocating air,
Gasket, cover plate
power driven
Lockwashers, cover plate (three required)
Hammer, ball-peen, machinist's
Oil, engine (item 32, appendix B)
Handle, ratchet, 112-inch drive
Rags, wiping (item 42, appendix B)
Handle, ratchet, 3/4-inch drive
Solvent, drycleaning (item 49, appendix B)
Indicator, dial
Puller, mechanical gear
Personnel Required
Punch, drive-pin, 1/4-inch
Remover/installer tool, camshaft
One
Socket, 1/2-inch drive, 9/16-inch
Socket, impact, 3/4-inch drive,
Equipment Condition
1 7/16-inch
Wrench, impact, power driven,
Front crankcase cover removed
3/4-inch drive
Wrench, open-end, 2-inch
Wrench, torque, 1/2-inch drive
Wrench, torque, 3/4-inch drive
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
1. Cylinder block (1)
Camshaft (2)
Using dial indicator, measure and record
end play.
If end play is more than 0.0035 to
0.0115 inch (0.089 to 0.292 mm) the
camshaft thrust plate must
be replaced.
2. Camshaft timing
Two screws (4)
Using 9/16-inch socket and ratchet handle
gear (3)
with 1/2-inch drive, unscrew and take out.
2-184
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |