Figure 2-4. Window and Skylight wire diagrams.

NOTE

This grid system may be tied into the panel system by

splicing the beginning of the wire on the window or

skylight to the end wire of the panel vertical grid.

Figure 2-5. Shutter grid wire diagram.

(2) Proceed horizontally across the shutter,

applying the wire in the same manner the horizontal'

grid wire is applied to a wall panel.

(3) When the grid wire reaches the top of the

shutter, run the wire back to the hinged side of the

shutter. Leaving a S-inch loop, run the wire over the

top of the shutter and apply a wire grid in the same

manner as described above. (fig. 2-4.)

Figure 2-4. Window and Skylight wire diagrams.

(4) Connect the grid wire to the junction box

NOTE

This grid system may be tied into the panel system by

terminals, as applicable.

splicing the beginning of the wire on the shutter to the

(5) Perform the installation checkout of para-

end of the horizontal wire of the panel. Shutter end grid

graph 2-7.

wire should then be connected to the junction box.

(6) Replace junction box cover after J-SIID

system wiring has been completed.

(4) Connect the grid wires to the junction box

d. Shutter Installation Procedure: Perform the

terminals, as applicable.

following steps to install the grid wire sensor:

(5) Perform the installation checkout of para-

NOTE

graph 2-7.

If the shutter is to be permanently closed, treat it as

(6) Replace the junction box cover after J-SIID

part of the wall panel and apply the wire in the .same

system wiring has been completed.

manner as it is applied to the rest of the panel.

e. Grid Wire Splicing Procedure. Grid wire splicing

(1) If the shutters are to be opened, start by

shall be performed in the following manner:

applying the wire to the window frame at the bottom

(1) Take a small piece of sandpaper and fold in

of the shutter. Leave a 3-inch service loop for

half. The rough sides of the sandpaper should be

crossing from the window frame to the shutter. This

facing each other.

allows the window to be opened without breaking the

(2) Place the wire to be spliced between the folded

wires. See figure 2-5.

2-5