Click here to make tpub.com your Home Page

Page Title: Figure 3-15. Removing timber blocking
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 5-5430-209-12
(b) Set stave (1) in position with its left
seam outside the right seam of next-to-last stave (4)
and its right seam inside the left seam of first stave (5).
Loosen bottom chime nuts (6) of stave (5).
(c) Lift first stave (5) slightly so bottom
chime of last stave (1) slips into place. Use drift pins (3,
fig. 3-12) and aline bolts in staves (1, 4, and 5, fig. 3-
14). Follow procedure in step (3) (c) above.
(d) Install nuts (6, fig. 3-14) on bolts (2)
in bottom chime. Install 1/2-by 1 2 -inch scaffold
mounting bolts in the third and twentieth bolt holes,
counting down from top chime, in vertical seam of every
stave. Install remaining bolts in all seams.
Install recessed washers (cup side down) and nuts
(rounded face down) on all bolts. Do not tighten.
(e) Tighten all bottom chime bolts
uniformly. Remove blocking (1, fig. 3-15) placed under
bottom chime. Use a heavy long timber (2) as a lever
and short timbers (3) as a fulcrum to lift the chime.
Tighten all seam bolts; be careful not to crush the
gaskets.
1. BLOCKING
2. HEAVY LONG TIMBER
3. SHORT TIMBER
Figure 3-15. Removing timber blocking
3-14

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business