Click here to make tpub.com your Home Page

Page Title: Figure 3-12. Aligning staves
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 5-5430-209-12
(b) Assemble the hook ladder (1, fig. 3-
13) and hook it over the inside of the staves.
1.
FIRST INTERMEDIATE STAVE
2.
FIRST STAVE
3.
DRIFT PIN
4.
NUT
Figure 3-12. Aligning staves.
1. HOOK LADDER
(b) Set stave (1) in position with its left
2. BOLT HEADS
seam outside the right seam of first stave (2). Use drift
3. STAVE JOINT CHANNEL
pins (3) in open bolt holes to aline stave. Install nuts (4)
only at every sixth or tenth bolt in the row.
Figure 3-13. Driving bolt heads into channels.
CAUTION
Install steel recessed washers on all
(c) As staves are installed, stand on
vertical seam bolts.
ladder (1) and fit all bolt heads squarely into the
NOTE
channels (3).
CAUTION
As the remaining staves are installed,
All bolt heads must be fitted squarely
check  carefully  the  position  and
tightness of all radii, wedge, and strip
into stave joint channels to insure
gaskets.
proper tightening of nuts.
(3) Remaining Intermediate Staves.
(4) Last stave.
(a) Face  the  outside  of  the  first
(a) To assist installation of this stave
intermediate stave and install three staves to the right of
(1, fig. 3-14), push all bolts (2) flush with gasket (3) in
the second stave or in a counterclockwise direction
chime at bottom to provide clearance for sliding in the
around the bottom.
last stave.
3-12

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business