 |
|||
|
|
|||
|
Page Title:
Cab Flasher Head light and Dome Light Circuit. (Cont) |
|
||
| ||||||||||
|
|
 TM
9-2350-238-20-2
(2)
Flasher
indicator
lamp
is
not
operating
when
cab
signal
flasher
headlight
is
on.
Make
sure
MASTER
switch
is
OFF
before
repairing
electrical
com-
ponents. Failure to observe this warning could result in injury to
personnel.
Remove LED (1) from flasher indicator light (2), refer to page 2-271. Set
Step 1.
MASTER
switch
ON.
Set
FLASHER
SIGNAL
switch
ON.
Place
red
probe
in
socket. Ground black probe. If multimeter indicates about 24 volts, replace
LED. If multimeter indicates no voltage, set MASTER switch OFF, install
LED and go to step 2.
Make
sure
MASTER
switch
is
OFF
before
repairing
electrical
com-
ponents. Failure to observe this warning could result in injury to
personnel.
Disconnect lead 325C (1) from flasher indicator lamp (2). Place red probe in
Step 2.
lead 325C. Ground black probe. Set MASTER switch ON. Set FLASHER
SIGNAL switch ON. If multimeter indicates about 24 volts, replace flasher
indicator lamp, refer to page 2-297. If multimeter indicates no voltage,
repair lead 325C between flasher indicator lamp and flasher assembly, refer
to page 2-66. Set MASTER switch OFF. Set FLASHER SIGNAL switch OFF.
Connect
lead.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals