 |
|||
|
|
|||
|
Page Title:
Filter Bypass Indicator Circuit. (Cont) |
|
||
| ||||||||||
|
|
 TM
9-2350-238-20-2
(2)
Filter bypass indicator is not operating when level wind circuits are operating
normally.
Remove
lamp
(1)
from
filter
bypass
indicator,
refer
to
Connect
Step 1.
multimeter to contacts of lamp. If multimeter indicates about 1 ohm, install
lamp and go to step 2. If multimeter indicates infinity, replace lamp, refer
to page 2-296.
Remove
access
panel,
refer
to
Disconnect
lead
326
(1)
from
Step 2.
filter bypass indicator (circuit breaker side). Place red probe in lead 326.
Ground black probe. Set MASTER switch ON. If multimeter indicates about
24 volts, go to step 3. If multimeter indicates no voltage, go to step 4. Set
MASTER
switch
OFF.
Connect
lead.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals