|
|
TM 9-2350-238-20-1
NOTE
Tag all electrical leads during removal to aid in installation.
1 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. Remove only the hardware which secures the harness or lead being
removed.
2 Remove four screws (1), four Iockwashers (2), and receptacle connector (3). Tag and
disconnect bulkhead disconnect to circuit breakers and electrical components branched wiring
harness (4) from bulkhead receptacle assembly (5), and remove gasket (6).
3 Tag and disconnect nine shell connectors (7) from line connections.
4 Tag and disconnect bulkhead disconnect to circuit breakers and electrical components
branched wiring harness (4) from driver's heater electrical control box shell connectors (8).
5 Remove hexagon plain nut (9), cable terminal (10), lockwasher (11), and screw (12) from
pyrometer panel assembly (13).
6 Tag and disconnect plug connector (14) from pyrometer panel indicator light (15).
7 Tag and disconnect two shell connectors (16) from pyrometer panel toggle switch (17).
2-1043
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |