|
|
TM 9-2350-238-20-1
2-182. MAINTENANCE OF HEATER INSTALLATION KIT--ELECTRICAL WIRING (CONT).
Failure to remove or disconnect batteries before removing or installing any electrical
lead or wiring harness may result in injury or damage to equipment.
NOTE
Tag all electrical leads during removal to aid in installation.
1 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,
clips, ground screws, etc. Remove only the hardware which secures the harness or lead being
removed.
assembly (1) plug connector from vehicle bus receptacle connector (2).
3 Tag and disconnect six shell connectors (3) from line connections.
4 Remove four screws (4) and receptacle connector (5) from bulkhead disconnect. Tag and
disconnect bulkhead disconnects to master relay and circuit breaker special cable assembly (8).
from bulkhead disconnect and remove gasket (6).
5 Tag and disconnect plug connector (7) from master relay assembly (8).
2-1044
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |