Reassembly - TM-9-2350-238-20-10836

TM 9-2350-238-20-1

2-139. MAINTENANCE OF AUXILIARY DRIVE SHAFTS, UNIVERSAL JOINTS, AND

RELATED PARTS (CONT).

Do not clean lubricant from new bearings; keep new bearings wrapped until ready for

installation.

NOTE

Installation steps are written for one universal joint but apply to all six universal joints.

1 Place a wood block under propeller shaft (1) adjacent to shaft yoke (2).

2 Rotate propeller shaft (1) until ends of shaft yoke (2) are vertical.

3 Install cross assembly (3) into shaft yoke (2).

4 Place bearing (4) in position in top opening of shaft yoke (2).

5 Engage bearing surface of cross assembly (3) into bearing (4) and hold in position. Seat bearing.

6 Rotate propeller shaft (1) 180 degrees.

7 Place bearing (5) in position in opening of shaft yoke (2).

2-810