|
|
TM 9-2350-238-20-1
Engage bearing surface of cross assembly (3) into bearing (5) and hold in position. Seat
8
bearing.
Install retaining ring (6) into groove in shaft yoke (2) to secure bearing (5).
9
Rotate propeller shaft (1) 180 degrees.
10
Install retaining ring (7) into groove in shaft yoke (2) to secure bearing (4). Seat retaining ring.
11
Place yoke (8) on cross assembly (3) with bearing surfaces of cross inside yoke.
12
Rotate propeller shaft (1) until ends of yoke (8) are vertical.
13
Place bearing (9) in position in top opening of yoke (8).
14
Engage bearing surface of cross assembly (3) into bearing (9) and hold in position. Seat
15
bearing.
16
Rotate propeller shaft (1) 180 degrees.
17
Place bearing (10) in position in opening of yoke (8).
Engage bearing surface of cross assembly (3) into bearing (10) and hold in position. Seat
18
bearing.
19
Install retaining ring (11) into groove in yoke (8) to secure bearing (10).
Rotate propeller shaft (1) 180 degrees.
20
Install retaining ring (12) into groove in yoke (8) to secure bearing (9). Seat retaining ring.
21
Lubricate universal joint and propeller shaft (1) with hydraulic fluid per TM 9-2350-238-10 before
22
installation in vehicle.
INSTALLATION
1 Install clutch to line bearing unit propeller
shaft (1) in vehicle.
2 Install new gasket (2) and auxiliary drive
line ball bearing unit (3) on clutch to line
bearing unit propeller shaft (1).
3 Install four hexagon head capscrews (4)
and new Iockwire (5) to secure auxiliary
drive line ball bearing unit (3) to clutch to
line bearing unit propeller shaft (1).
2-811
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |