INSPECTION/REPAIR - TM-9-2350-238-20-10835

TM 9-2350-238-20-1

NOTE

Disassembly steps are written for one universal joint but apply to all six universal

joints.

1 Remove four retaining rings (1).

2 Support propeller shaft (2) with wood block placed under propeller shaft close to universal joint.

3 Rotate propeller shaft (2) so yoke (3) is positioned with bearing (4) facing up.

4 Tap yoke (3) with soft-faced hammer forcing bearing (4) from yoke. Remove bearing.

5 Rotate propeller shaft (2) 180 degrees so yoke (3) is positioned with bearing (5) facing up.

6 Tap yoke (3) with soft-faced hammer forcing bearing (5) from yoke. Remove bearing.

7 Remove yoke (3) from cross assembly (6).

8 Rotate and position propeller shaft (2) with bearing (7) in shaft yoke (8) facing up. Remove

bearing.

9 Rotate shaft yoke (8) 180 degrees and remove bearing (7).

10 Remove cross assembly (6) from shaft yoke (8).

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 Auxiliary drive line ball bearing unit is a repairable assembly. Notify direct support

maintenance.

3 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

2-809