|
|
TM 9-2350-238-20-1
2-129. MAINTENANCE OF FINAL DRIVE ASSEMBLY (CONT).
NOTE
The following steps are written and
illustrated for the left hand final drive
assembly, but apply to both the left
and right final drive assemblies.
1 Remove seven screws (1), seven washers
(2), and fender extension (3).
2 Remove drive sprocket hub assembly (4),
refer to page 2-869.
3 Remove four screws (5), four nuts (6), four
washers (7), and headlamp guard (8).
4 Remove 24 self-locking bolts (9).
5 Install final drive lifting sling by inserting
lifting sling dowel into bolt mounting hole
and placing lifting eye (10) over stud (11).
6 Install nut (12) on stud (11).
2-762
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |