Test

TM 9-2350-238-20-1

2-127. MAINTENANCE OF TRANSMISSION AND TRANSMISSION PLUGS (CONT).

Do not overfill transmission.

3 Check transmission oil level. Oil level

must be between ADD and FULL marks

on dipstick. Add or drain oil as necessary.

Refer to the PMCS/lubrication table, page

2-13.

NOTE

Steps 4 thru 6 are written for one

final drive but apply to both final

drives. Disconnect both right and left

final drives before performing

transmission pressure test.

4 Remove six screws (1), six Iockwashers

(2), and output drive cap (3).

5 Unscrew final drive coupling nut (4) from

transmission shaft (5), using drift and

hammer, or spanner wrench. Push final

drive coupling nut into final drive housing.

2-752