MAINTENANCE OF BULKHEAD TO BULKHEAD GENERATOR CIRCUIT ELECTRICAL LEAD.

TM 9-2350-238-20-1

2-97. MAINTENANCE OF BULKHEAD TO BULKHEAD GENERATOR CIRCUIT

ELECTRICAL LEAD.

This task covers:

a. Removal

d. Reassembly

b. Disassembly

e. Installation

c. Inspection/Repair

INITIAL SETUP

Driver's compartment aft cowl

2-928

Materials/Parts

removed

Electrical wire (figure D-2, appx D)

Gasket

General Safety Instructions

References

TM 9-2350-238-24P-1

Failure to remove or disconnect

Equipment Conditions

batteries before removing or installing

2-840 Batteries disconnected

any electrical wiring harness or lead

2-952 Driver's seat removed

may result in injury or damaged

2-928 Driver's compartment forward cowl

equipment.

removed

Failure to remove or disconnect

batteries before removing or installing

any electrical wiring harness or lead

may result in injury or damaged

equipment.

Wiring harnesses and leads are secured

to the hull and components with loop

clamps, straps, clips, ground screws, etc.

Remove only the hardware which secures

the wiring harness or lead being removed.

Tag and disconnect plug connector (1)

from voltage regulator.

Remove four screws (2) and four washers

(3), and tag and disconnect receptacle

connector (4) from front bulkhead recep-

tacle.

If damaged, remove gasket (5) from receptacle connector (4).

Remove bulkhead to bulkhead generator circuit electrical lead (6) from hull through driver's

compartment.

2-672