Installation - TM-9-2350-238-20-10699

TM 9-2350-238-20-1

For disassembly of wiring harness receptacle connector and plug connector, refer to general

maintenance, page 2-371.

1 Inspect for broken, damaged, or missing parts.

2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3 Electrical wire is a manufactured item, refer to appendix D.

4 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

For reassembly of wiring harness receptacle connector and plug connector, refer to general

maintenance, page 2-371.

Install bulkhead to bulkhead generator

circuit electrical lead (1) to hull through

driver's compartment.

If removed, install new gasket (2) to

receptacle connector (3).

Untag and connect receptacle connector

(3) to front bulkhead receptacle and install

four washers (4) and four screws (5).

Untag and connect plug connector (6) to

voltage regulator.

Wiring harnesses and leads are secured

to the hull and components with loop

clamps, straps, clips, ground screws, etc.

During installation, make sure the wiring

harness or lead is secure and all hardware

is tight.

2-673