INSPECTION/REPAIR - TM-9-2350-238-20-10697

TM 9-2350-238-20-1

For disassembly of wiring harness plug connector, refer to general maintenance, page 2-371.

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3 For repair of cable terminal, refer to general maintenance, page 2-371.

4 Electrical wire and insulation sleeving are manufactured items, refer to appendix D.

5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

For reassembly of wiring harness plug connector, refer to general maintenance, page 2-371.

Install bulkhead disconnect to starter

electrical lead (1) to engine.

Connect cable terminal (2) to starter.

Connect plug. connector (3) to bulkhead

disconnect.

Wiring harnesses and leads are secured

to the engine with loop clamps, straps,

ground screws, etc. During installation,

make sure the wiring harness or lead is

secure and all hardware is tight.

2-671