|
|
46TM 9-2350-238-20-1
INSPECTION/REPAIR
1 Inspect for broken, damaged, or missing parts.
2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.
3 For repair of cable terminal and shell connector, refer to general maintenance, page 2-371.
4 Electrical wire and insulation sleeving are manufactured items, refer to appendix D.
5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).
INSTALLATION
1
Install battery to circuit breaker electrical
lead (1) to hull.
Connect shell connector (2) to circuit
2
breaker.
Connect cable terminal (3) to battery
3
terminal (4).
4
Wiring harnesses and leads are secured
to the hull and components with loop
clamps, straps, clips, ground screws, etc.
During installation, make sure the wiring
harness or lead is secure and all hardware
is tight.
5
Close battery access cover (5).
2-667
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |