 |
|||
|
|
|||
|
Page Title:
MAINTENANCE OF BATTERY TO CIRCUIT BREAKER ELECTRICAL LEAD. |
|
||
| ||||||||||
|
|
 TM 9-2350-238-20-1
2-94. MAINTENANCE OF BATTERY TO CIRCUIT BREAKER ELECTRICAL LEAD.
This task covers:
a. Removal
b. Inspection/Repair
c. Installation
INITIAL SETUP
Materials/Parts
General Safety Instructions
Electrical wire (figure D-2, appx D)
Insulation sleeving (figure D-22, appx D)
References
Failure to remove or disconnect
TM 9-2350-238-24P-1
batteries before removing or installing
any electrical wiring harness or lead
may result in injury or damaged
Equipment Conditions
equipment.
2-840 Batteries disconnected
2-918 Hull access cover removed
REMOVAL
Failure to remove or disconnect
batteries before removing or installing
any electrical wiring harness or lead
may result in injury or damaged
equipment.
1
Open battery access cover (1).
Wiring harnesses and leads are secured
2
to the hull and components with loop
clamps, straps, clips, ground screws, etc.
Remove only the hardware which secures
the wiring harness or lead being removed.
Disconnect cable terminal (2) from battery
3
terminal (3).
4
Disconnect shell connector (4) from circuit
breaker.
Remove battery to circuit breaker electrical
5
lead (5) from hull.
2-666
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals