INSPECTION/REPAIR - TM-9-2350-238-20-10691

TM 9-2350-238-20-1

For disassembly of wiring harness receptacle connector, refer to general maintenance, page 2-371.

INSPECTION/REPAIR

1 Inspect for broken, damaged, or missing parts.

2 If damaged or missing, replace marker bands. Etch or stamp lead number on new band.

3 For repair of shell connectors and cable terminals, refer to general maintenance, page 2-371.

4 Electrical wire and rod are manufactured items, refer to appendix D.

5 Repair is by replacement of authorized parts (TM 9-2350-238-24P-1).

For reassembly of wiring harness receptacle connector, refer to general maintenance, page 2-371.

1 Enter rear hull well and install trailer receptacle assembly to disconnect wiring harness (5) to

hull.

2 Connect two cable terminals (4) to ground.

3 Connect receptacle connector (3) to trailer receptacle and install four screws (2).

4 Connect five shell connectors (1) to bulkhead disconnect to trailer receptacle disconnect

branched wiring harness.

5 Wiring harnesses and leads are secured to the hull and components with loop clamps, straps,

clips, ground screws, etc. During installation, make sure the wiring harness or lead is secure

and all hardware is tight.

2-665