NONSKID AREAS.

TM 9-2350-238-20-1

Do not use solvent to clean rubber parts. Clean rubber parts by washing with mild solution of

soap and water.

Dry parts by blowing with low-pressure compressed air or wiping with clean, lint-free cloths

(item 12, appx C).

Bearings should be cleaned by procedures in TM 9-214.

Spot paint metal surfaces after repairs, as required. Sand damaged areas, clean with solvent,

and rinse with water. Surface must be clean and dry. Paint with- CARC to match existing color,

refer to TM 43-0139.

2-30. LUBRICATION. Keep a light coat of preservative lubricant cleaner (CLP) (item 8, appx C)

on parts during repair procedures to prevent rusting. Lubricate parts during repair and assembly as

required by PMCS/lubrication table, page 2-13.

2-31. PAINTING INSTRUCTIONS. Complete painting is authorized for and done by general

support maintenance personnel or higher. Spot painting and restenciling vehicle markings is done

by unit maintenance personnel. Instructions for materiel preparation, priming, and finish are given in

TM 43-0139.

2-32. NONSKID AREAS.

Walkway compound (item 46, appx C) will be used to coat deck areas where personnel walk. The

seven areas (1 thru 7) to be coated with nonslip paint are shown in the above illustration.

2-33. TOUCHUP AND RECOATING.

Chemical Agent Resistant Coating (CARC) Paint: CARC paint contains isocyanate, a

constituent that can cause respiratory effects during and after the application of the

material. During the application of CARC paint, coughing, shortness of breath, pain on

2-381