|
|
TM 9-2350-238-20-1
2-19. TYPICAL MALE-TYPE PLUG CONNECTOR (CONT).
REASSEMBLY
1
Strip cable of insulation equal to depth of
solder wells of pin contacts (1).
2
Slide nut (2) over cable (3).
3
Slide grommet (4) over cable leads (5).
4
Insert cable leads (5) into solder wells of
pin contacts (1) and solder.
Push insert (6) into shell assembly (7)
5
from rear until seated. Groove (8) in
insert (6) must be aligned with guide in
shell assembly (7) to ensure proper fit.
Push pin contacts (1) into insert (6) from
6
rear until seated.
7
Slide coupling (9) onto shell assembly (7).
Push grommet (4) down cable leads (5) and over solder wells of pin contacts (1).
8
Screw nut (2) onto shell assembly (7).
9
2-20. REPLACING CABLE TERMINALS AND SHELL CONNECTORS.
CABLE TERMINALS
1
Strip cable insulation equal to depth of
terminal well (1).
Slide insulator (2) over cable (3).
2
Insert cable (3) into terminal well (1) and
3
crimp.
4
Slide insulator (2) over crimped end of
terminal (4).
2-376
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |