|
|
TM 9-2350-238-20-1
2-120 ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Step 4.
Place red probe on pin E (lead 410). Place black probe on pin C (lead
401). Set START-OFF-RUN switch to RUN. If multimeter indicates 0
ohms, go to step 5. If multimeter indicates infinity, replace personnel heater
control box. Refer to page 2-1103. Set START-OFF-RUN switch OFF.
Connect wiring harness.
Step 5.
Place red probe on pin E (lead 410). Place black probe on pin B (lead
402). Set HI-LO switch to HI. If multimeter indicates 0 ohms, go to step 6.
If multimeter indicates infinity, replace personnel heater control box. Refer
to page 2-1103. Connect wiring harness.
2-364
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |