|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 2.
To access personnel heater circuit breaker, remove left C02 cylinder cover.
Refer to page 2-923. Disconnect battery power lead from circuit breaker.
Place red probe in battery power lead. Ground black probe. If multimeter
repair battery power lead. Refer to page 2-371. If problem still exists,
troubleshoot battery power circuit. Refer to page 2-82. Connect lead.
Step 3.
Disconnect lead 401 from 30A circuit breaker. Connect multimeter to 30A
circuit breaker receptacles. If multimeter indicates 0 ohms, go to step 4. If
multimeter indicates infinity, replace 30A circuit breaker. Refer to page
2-360
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |