|
|
TM 9-2350-238-20-1
BN. PERSONNEL HEATER CONTROL BOX LIGHT CIRCUIT.
Make sure MASTER switch is OFF before repairing
electrical circuits. Failure to observe this warning
could result in injury to personnel.
Step 1.
Remove lamp from personnel heater control box. Refer to page 2-1055.
Connect multimeter to contacts of lamp. If multimeter indicates about 75
ohms, go to step 2. If multimeter indicates 0 ohms, replace lamp. Refer to
2-359
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |