|
|
TM 9-2350-238-20-1
2-12. ELECTRICAL CIRCUIT TROUBLESHOOTING (CONT).
Make sure MASTER switch is OFF before repairing electrical
circuits. Failure to observe this warning could result in injury to
personnel.
Step 3.
To access bulkhead disconnect, remove driver's seat, refer to page 2-952;
and remove driver's compartment aft cowl, refer to page 2-928. Disconnect
wiring harness. Place red probe in pin E (lead 23). Ground black probe.
Set MASTER switch ON. Turn vehicular light switch to BO STOP. Apply
brakes. If multimeter indicates about 24 volts, repair lead 23 between
bulkhead disconnect and right stoplight-taillight. Refer to page 2-371. If
multimeter indicates no voltage, go to step 4. Set MASTER switch OFF.
Turn vehicular light switch OFF. Connect wiring harness.
Step 4.
Place red probe on pin A. Place black probe on pin F. Turn vehicular light
switch to BO STOP. If multimeter indicates 0 ohms, go to step 5. If
multimeter indicates infinity, replace vehicular light switch. Refer to page
2-252
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |