|
|
TM 9-2350-238-20-1
Check resistance between plug pin G (lead 2) and ground. If multimeter
Step 4.
indicates 0 to 4 ohms, go to step 8. If multimeter indicates more than 4
ohms, go to step 5. Connect wiring harness to voltage regulator.
To access engine disconnect, remove hull transmission compartment deck
Step 5.
assembly. Refer to page 2-938. Disconnect wiring harness at engine
disconnect. Check resistance between plug socket (lead 2) and ground. If
multimeter indicates 0 to 4 ohms, go to step 6. If multimeter indicates
more than 4 ohms, go to step 7. Connect wiring harness at engine
disconnect.
2-135
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |