|
|
TM 9-2350-238-20-1
Table 2-3. UNIT TROUBLESHOOTING (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
94. HYDRAULIC SUSPENSION LOCKOUT CYLINDER ASSEMBLY DOES NOT LOCK.
Check for leaks and damaged or clogged tubes, hoses, and fittings.
Step 1.
Tighten loose connections.
a.
Replace leaking or damaged components. Refer to page 2-894 and
b.
If problem still exists, notify direct support maintenance.
Step 2.
95. HYDRAULIC SUSPENSION LOCKOUT CYLINDER ASSEMBLY DOES NOT UNLOCK.
Step 1.
Check for damaged or faulty lockout cylinder manifold check valve.
Replace lockout cylinder manifold check valve. Refer to page 2-887.
If problem still exists, notify direct support maintenance.
Step 2.
HYDRAULIC SYSTEM
96. HYDRAULIC SYSTEM PRESSURE TOO LOW.
Step 1.
Check HYD PUMP/PTO CLUTCH switch.
Set HYD PUMP/PTO CLUTCH switch ON with engine at idle speed.
Step 2.
Check hydraulic system pressure valve.
Close valve if open.
Step 3.
Check hydraulic fluid level.
Fill hydraulic system with proper fluid. Refer to TM 9-2350-238-20-2.
Step 4.
Check for any hydraulic leaks.
Repair hydraulic leaks. Refer to page 2-781, page 2-797, and page
If problem still exists, notify direct support maintenance.
Step 5.
2-85
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |