MAINTENANCE OF HYDRAULIC POWER SUPPLY LINES AND FITTINGS (AFT SECTION).

TM 9-2350-238-20-1

2-137. MAINTENANCE OF HYDRAULIC POWER SUPPLY LINES AND FITTINGS (AFT

SECTION).

b. hspection/Repair

c. lnstallation

This task covers:

a. Removal

INITIAL SETUP

Materials/Parts

Locknut

Lockwasher (6)

Preformed packing (2)

Preformed packing (5)

References

TM 9-2350-238-24P-1

General Safety Instructions

To avoid injury to personnel, do not tighten or loosen hydraulic fittings when

system is pressurized.

Lower the boom to stowed position before doing any maintenance on hydraulic

system.

. Wipe up any spilled hydraulic fluid to prevent injury to personnel.

REMOVAL

To avoid injury to personnel, do not tighten or loosen hydraulic fittings when system

is pressurized.

Lower the boom to stowed position before doing any maintenance on hydraulic

system.

Wipe up any spilled hydraulic fluid to prevent injury to personnel.

Install covers on open hydraulic ports, tubes, and hoses immediately after disconnect-

ing them to keep dirt out of hydraulic system.

NOTE

Access to aft hydraulic power supply fittings is gained through the cab well.

2-797