Click here to make tpub.com your Home Page

Page Title: APPENDIX H TORQUE VALUES FOR THREADED FASTENERS
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2330-202-14&P
TORQUE VALUES FOR THREADED FASTENERS
Paragraph
Page
Paragraph Title
Number
Number
General ..................................................................................................................... H-1
Torque Limits.............................................................................................................. H-1
How To Use Torque Table ............................................................................................ H-1
Tightening Metal Fasteners ........................................................................................... H-3
Fastener Size and Thread Pattern .................................................................................. H-4
Fastener Grade ........................................................................................................... H-5
GENERAL.
This section provides general torque limits for screws used on the M101 and Ml 16 Series trailer. Special torque limits
are indicated in the maintenance procedures for applicable components.  The general torque limits given in this
appendix shall be used when specific torque limits are not indicated in the maintenance procedure. These general
torque limits cannot be applied to screws that retain rubber components. The rubber components will be damaged
before the correct torque limit is reached. If a special torque limit is not given in the maintenance instructions, tighten
the screw or nut until it touches the metal bracket, then tighten it one more turn.
TORQUE LIMITS.
Table H-1 lists dry torque limits. Dry torque limits are used on screws that do not have lubricants applied to threads.
Table H-2 lists wet torque limits. Wet torque limits are used on screws that have high-pressure lubricants applied to
threads.
HOW TO USE TORQUE TABLE.
1.
Measure the diameter of the screw to be
installed.
2.
Count the number of threads per inch or use a
pitch gage.
3.
Under the heading SIZE, look down the left-
hand column until the diameter of screw to be
installed is found (there will usually be two lines
beginning with the same size).
4.
In the second column under SIZE,  find the
number of threads per inch that matches the
number of threads counted in step 2.

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business