CLEANING AND INSPECTION - TM-9-2330-202-14-P0210

TM 9-2330-202-14&P

4-54.

SPRING ASSEMBLY REPLACEMENT (continued).

11. Remove lubrication fitting (23) from each of three shackle pins (19, 20, and 13) and discard.

b. CLEANING AND INSPECTION

WARNING

Drycleaning solvent P-D-680 is toxic and flammable. Always wear protective goggles and gloves,

and use only in a well-ventilated area. Avoid contact with skin, eyes, and clothes, and DO NOT

breathe vapors. DO NOT use near open flame or excessive heat.

1. Clean all removed components with drycleaning solvent and rag and allow to dry. Make sure lubrication passages in

shackle pins are clear.

2. Inspect all removed components for cracks, breaks, corrosion, or damaged threads. Replace if damaged.

c. INSTALLATION

1. Loosely install two shackles (14

and 15) on rear spring hanger (10)

with shackle pin (20) and slotted

nut (22).

2. Position spring assembly (6) above

axle (1).

3. At front spring hanger (16), loosely

install spring assembly (6) on frame

(9) with shackle pin (19) and slotted

nut (18).

4. At rear spring hanger (10), loosely

install spring assembly (6) on two

shackles (14 and 15) with shackle

pin (13) and slotted nut (12).

5. Use floor jack to raise axle (1) until

it contacts underside of spring

assembly 6). Engage spring

assembly center bolt head (24) with

hole in spring mounting pad (25).

4-106