 |
|||
|
|
|||
|
Page Title:
SERVICE BRAKE ADJUSTMENT (M101A1 AND M116A1) |
|
||
| ||||||||||
|
|
 TM 9-2330-202-14&P
4-36.1 SERVICE BRAKE ADJUSTMENT (M101A1 AND M116A1).
This Task Covers:
Adjustment
Initial Setup:
Tools/Test Equipment:
Common No. 1 tool set (Item 2, Appendix B)
General mechanic's tool kit (Item 1, Appendix B)
ADJUSTMENT
NOTE
The procedure for adjusting the service brake is the same for the left side and the
right side.
1.
Apply handbrakes (para 2-10). Chock wheel and tire assembly (1) opposite side of service brake
being adjusted.
2.
Raise axle (2) on side being adjusted until wheel and tire assembly (1) is off the ground.
3.
Release handbrake on side being adjusted (para 2-10).
4.
While turning wheel and tire assembly (1), turn cam stud (3) until brake drags. Turn cam stud in
opposite direction just enough to remove drag.
5.
Repeat step 4 for other cam stud (4).
6.
Remove button plug (5).
7.
Loosen nut (6) and turn eccentric pin (7) until it binds. Tighten nut.
8.
Install button plug (5).
9.
Lower axle (2). Apply handbrake on adjusted side (para 2-10).
438-003
FOLLOW-ON TASKS:
Adjust handbrakes (para 4-34).
.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals