Click here to make tpub.com your Home Page

Page Title: Run Flat Mode
Back | Up | Next

Click here for thousands of PDF manuals

Google


Web
www.tpub.com

Home


   
Information Categories
.... Administration
Advancement
Aerographer
Automotive
Aviation
Construction
Diving
Draftsman
Engineering
Electronics
Food and Cooking
Logistics
Math
Medical
Music
Nuclear Fundamentals
Photography
Religion
   
   

 

TM 9-2320-386-10
2-19. OPERATION OF CENTRAL TIRE INFLATION SYSTEM (CTIS) (Contd)
c. Run Flat Mode.
CAUTION
If tire condition deteriorates and cannot maintain at least fifty
percent of its lowest set point, run flat mode should be aborted to
prevent equipment damage.
NOTE
By pressing a terrain switch on the control panel, a vehicle operator
can start a pressure check cycle, beginning with the initial test
pressure sequence. After the initial test pressure sequence has
started, if air feeder lines and tires cannot hold at least 6 psi
(41 kPa), the system will sense a failure and the control panel dis-
play will read FLAT. With the presence of a flat tire indicated, the
vehicle operator may elect to call for assistance, or he may try
to drive to a repair center using the vehicle's run flat mode.
Run flat mode supplies pressure to the air lines and to all wheel valves
and allows maximum possible air pressure to the damaged tire.
RUN FLAT ACTIVE will be displayed on the LCD and the tire
pressure will be indicated in flashing lower case PSI.
(1) Run flat mode is engaged by pressing and holding for three seconds the
terrain button that the tire failure occurred in.
NOTE
PRESSURE ADJ. ABORT will be shown on the LCD, followed by
the normal display for the selected terrain when the set point is
reached.
By aborting any setting, the ECU will be in a stand by mode.
Ensure the correct terrain button is pressed and the CTIS is
allowed to complete a cycle to start the auto timer in the ECU.
(2) Run flat mode can be aborted by pressing any terrain switch.
CAUTION
In the event of CTIS failure, pressure/speed limitations displayed on
data plate must be observed when manually inflating/deflating tires.
(3) In the event of system failure, tires may be inflated manually (para. 3-9).
Table 2-3. Required CTIS Limits.
TIRE
ALLOWABLE DRIVING
SET
CONDITION
POINTS
PRESSURE RANGE
SPEED RANGE
Highway
45 psi
43-47 psi (296-324 kPa)
0-56 All Speeds
Cross-Country
33 psi
31-35 psi (214-241 kPa)
0-36 mph
Sand/Mud/Snow
20 psi
18-22 psi (124-152 kPa)
0-16 mph
Emergency
13 psi
11-15 psi (76-103 kPa)
0-5 mph
d. Operation in Extreme Cold.
Turn OFF the CTIS during operation in extreme cold, -0 to -65F (-18 to -54C).
Change 1

Privacy Statement - Press Release - Copyright Information. - Contact Us

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business