Installation - TM-9-2320-360-20-20882

TM 9-2320-360-20-2

(3) Install yokes (4 and 5) on U-joint (6).

CAUTION

Use care when installing bearing

caps. Bearings may fall out and be

damaged.

(4)

Install four bearing caps (7) through yokes (4

and 5) onto U-joint (6).

(5) Install four retaining rings (8) on bearing caps

(7).

(6) Install four bearing caps (9) through yokes (10

and 11) onto U-joint (12).

(7) Install four retaining rings (13) on bearing caps

(9).

(8) Install grease fitting (14) in shaft (2).

f. Installation

(1) Deleted.

(2) Deleted.

WARNING

Support

shaft

when

Installing

hardware to prevent It from falling.

Failure to comply may result in

serious Injury.

NOTE

Align matchmarks on shaft and

steering gear.

Shaft must be

aligned for proper steering timing

(front and rear gears).

To install no. 1 steering shaft, do

steps (17) thru (19).

To install no. 2 steering shaft, do

steps (7) thru (17).

To install no. 3 steering shaft, do

steps (3) thru (7) and (11).

To install no. 4 steering shaft, do

steps (2.1), (5), and (6).

To install no. 5 steering shaft, do

steps (20) and (21).

(2.1) Install yoke (1) from steering shaft no. 4

(1.1) on gear reducer (1.2) with screw (1.3) and new

locknut (1.4). Torque to 35-40 lb-ft (48-54 Nm).

13-31