Installation cont'd - TM-9-2320-360-20-20883

TM 9-2320-360-20-2

13-7. REAR STEERING SHAFTS NO. 1, NO. 2, NO. 3, NO. 4, AND NO. 5 REPAIR (CONT)

WARNING

Support shaft during installation to

prevent It from falling. Failure to

comply may result in serious Injury.

NOTE

Pass shaft between ramps, under

fifth wheel, and over no. 2 axle

torque arm, between left frame and

crossmember in front of no. 2 axle.

Shaft no. 3 should be connected to

shaft no. 2 before installing carrier

bearing.

(3) Position steering shaft no. 3 (7) along frame (2)

with aid of assistant.

(4) Install spacer (7.1) and carrier bearing (8) on

frame (2) with two screws (9) and new locknuts

(10) with aid of assistant. Torque to 44 lb-ft (60

Nm).

(5) Install yoke (11) from steering shaft no. 4 (1.1)

on steering shaft no. 3 (7).

(6) Install screw (12) and new locknut (13) in yoke

(11). Torque to 35-40 lb-ft (48-54 N m).

(7) Install steering shaft no. 2 (14) in yoke (15).

(8) Install front carrier bearing (16) on frame (2) with

two screws (17) and new locknuts (18). Do not

tighten.

(9) Install rear carrier bearing (19) and shim (20) on

frame (2) with two screws (21) and new locknuts

(22). Do not tighten.

(10) Tighten four locknuts (18 and 22) to 44 Ib-ft (60

Nm).

(11) Install screw (23) and new locknut (24) through

yoke (15). Torque to 35-40 Ib-ft (48-54 Nm).

13-32 Change 1