Steering Shaft No. 3 Assembly

TM 9-2320-360-20-2

13-7.

REAR STEERING SHAFTS NO. 1, NO. 2, NO.

3, NO. 4, AND NO. 5 REPAIR (CONT)

d. Steering Shaft No. 3 Assembly

(1) Install yokes (1 and 2) on U-joint (3).

CAUTION

Use care when installing bearing caps.

Bearings may fall out and be

damaged.

(2) Install four bearing caps (4) through yokes (1

and 2) onto U-joint (3).

WARNING

Wear eye protection and use care

when Installing retaining rings.

Retaining rings are under spring

tension and can act as projectiles

when released causing severe eye

Injury.

(3) Install four retaining rings (5) on bearing caps

(4).

(4) Install grease fitting (6) in shaft (7).

e. Steering Shafts No. 1, No. 4, and No. 5 Assembly

(1) Install dust cap (1) on shaft (2).

CAUTION

Both upper and lower yokes must be

in same position. Arrows on upper

and lower shafts must align. Failure

to comply may result in steering

shaft binding.

(2) Install splined shaft (3) on shaft (2).

13-30